Firefighters battling a blaze on the Summerland Way at Clearfield, near Rappville, south of Casino.
Firefighters battling a blaze on the Summerland Way at Clearfield, near Rappville, south of Casino. Casino Rural Fire Brigade

Fire permits now required for Valley region

FIRE permits are now required for the Clarence Valley region after the bush fire danger period was brought into effect on Tuesday.

The original September 1 danger period date was brought forward following an outbreak of more than 20 fires across the region for the past week.

Here's everything you need to know about these changes:

The key things to remember

You need a fire permit if it's the Bush Fire Danger Period.

Just because it's the Bush Fire Danger Period doesn't mean you can't use fire - but there are restrictions to ensure fire is used safely.

Getting a permit is free and easy. Contact your local Fire Control Centre.

There are heavy penalties if you don't follow restrictions or rules.

Please note that other restrictions, approvals and/or permits may apply to council areas where the Bush Fire Danger Period has not been declared. For example, backyard burning is not permitted in many suburban areas due to Environmental Regulations and Council or Environmental Protection Authority (EPA) permission is required.

Check these guides for more information on permits and reducing hazards on your property:

Before You Light That Fire - information on permits and steps you need to take before using fire on your property

Can I or Can't I - a simple guide to restrictions such as during Total Fire Bans

What is a Fire Permit?

Fire Permits help ensure fire is used safely during the Bush Fire Danger Period. A permit imposes conditions on the way a fire is lit and maintained and can only be issued by authorised Permit Issuing Officers.

The permit system ensures agencies like the NSW RFS know when and where landholders intend to burn, to ensure adequate and appropriate measures are in place, and so that fires remain under control.

To carry out a Bush Fire Hazard Reduction Burn, you may need:

  • a Fire Permit and/or
  • an Environmental Approval such as a Bush Fire Hazard Reduction Certificate. You must gain this before applying for a Fire Permit.
  • The Permit Issuing Officer may add any conditions deemed as necessary but all permits have standard conditions that, such as:
  • the permit is to be carried by the permit holder, on site, at the time the fire is lit
  • the permit is to remain on site with those present until extinguished, if applicable
  • the fire must be supervised at all times unless the permit says otherwise
  • notifications are given to the NSW RFS, and adjoining neighbours at least 24 hours (unless specified otherwise) prior to the fire being lit and
  • the permit may be varied, cancelled or suspended, depending on weather conditions.

When are permits required?

The statutory Bush Fire Danger Period runs from 1 October to 31 March, however it may vary due to local conditions. If you are planning to light a fire in the open during this time, you will need a Fire Permit.

You can find out if permits are required in your area below.

Also depending on the type of fire, a permit may be required all year round. For example, a Fire Permit is required at all times if a fire is likely to be dangerous to a building.

When are permits not required?

Fire Permits are not required for fires that are lit for the purpose of land clearance or the creation of a fire break during the Non Bush Fire Danger Period.

Additionally, Fire Permits are not required for fires for the purpose of cooking food, provided that:

the fire is in a permanently constructed fireplace;

at a site surrounded by ground that is cleared of all combustible materials for a distance of at least two metres all around;

the fire is completely extinguished before leaving.

What else do I need to do?

Before lighting the fire ensure that:

it can be contained and controlled within the specified area

it does not contain toxic materials, such as rubber tyres, plastics, paint etc; and

it must not cause an air pollution problem by producing excessive amounts of smoke.

If you have a permit, it is your responsibility to:

check whether a Total Fire Ban in force on our Fire Danger Ratings and Total Fire Ban page. If there is, your permit is automatically suspended.

check whether a No Burn day has been declared on the EPA website

check the expected weather conditions

notify and check with your local NSW RFS Fire Control Centre or Fire and Rescue NSW station prior to lighting.

follow any conditions restrictions listed in your permit.

Applying for a permit

If in doubt about whether you require a Fire Permit, or to apply for one, contact your local NSW RFS Fire Control Centre or Fire and Rescue NSW station.

Fines and penalties

Substantial fines and prison terms of up to 12 months may apply to persons found to be in breach of the Rural Fires Act 1997 and its Regulations.

Civil law suits can also be bought against persons responsible for fire, by those seeking compensation, for losses sustained.   



High price of school principal Facebook post

premium_icon High price of school principal Facebook post

Couple face losing their home after posting defamatory comments

Lift-off for Dreamworld’s new attraction

premium_icon Lift-off for Dreamworld’s new attraction

Sky Voyager officially takes off at Dreamworld

Fire destroys dwelling as blaze continues to burn

premium_icon Fire destroys dwelling as blaze continues to burn

RFS warns people to be vigiliant this weekend